Re: Question about DROP TABLE

Hi Pavel,
thanks for the information. I've been doing more investigation of this
issue and there's autovacuum running on the table however it's
automatically starting even if there is "autovacuum = off" in the
postgresql.conf configuration file.

The test of rm 5T file was fast and not taking 24 hours already. I guess
the autovacuum is the issue. Is there any way how to disable it? If I
killed the process using 'kill -9' yesterday the process started again.

Is there any way how to cancel this process and disallow PgSQL to run
autovacuum again and do the drop instead?

Thanks,
Michal

On 01/12/2016 12:01 PM, Pavel Stehule wrote:
> Hi
>
> 2016-01-12 11:57 GMT+01:00 Michal Novotny <michal(dot)novotny(at)trustport(dot)com
> <mailto:michal(dot)novotny(at)trustport(dot)com>>:
>
> Dear PostgreSQL Hackers,
> I've discovered an issue with dropping a large table (~5T). I was
> thinking drop table is fast operation however I found out my assumption
> was wrong.
>
> Is there any way how to tune it to drop a large table in the matter of
> seconds or minutes? Any configuration variable in the postgresql.conf or
> any tune up options available?
>
>
> drop table should be fast.
>
> There can be two reasons why not:
>
> 1. locks - are you sure, so this statement didn't wait on some lock?
>
> 2. filesystem issue - can you check the speed of rm 5TB file on your IO?
>
> Regards
>
> Pavel
>
>
>
>
>
>
> PostgreSQL version used is PgSQL 9.4.
>
> Thanks a lot!
> Michal
>
>
> --
> Sent via pgsql-hackers mailing list (pgsql-hackers(at)postgresql(dot)org
> <mailto:pgsql-hackers(at)postgresql(dot)org>)
> To make changes to your subscription:
> http://www.postgresql.org/mailpref/pgsql-hackers
>
>