The basic output plugin callbacks (e.g.,
message_cb) are only invoked when the transaction actually commits. The changes are still decoded from the transaction log, but are only passed to the output plugin at commit (and discarded if the transaction aborts).
This means that while the decoding happens incrementally, and may spill to disk to keep memory usage under control, all the decoded changes have to be transmitted when the transaction finally commits (or more precisely, when the commit is decoded from the transaction log). Depending on the size of the transaction and network bandwidth, the transfer time may significantly increase the apply lag.
To reduce the apply lag caused by large transactions, an output plugin may provide additional callback to support incremental streaming of in-progress transactions. There are multiple required streaming callbacks (
stream_change_cb) and two optional callbacks (
stream_truncate_cb). Also, if streaming of two-phase commands is to be supported, then additional callbacks must be provided. (See Section 49.10 for details).
When streaming an in-progress transaction, the changes (and messages) are streamed in blocks demarcated by
stream_stop_cb callbacks. Once all the decoded changes are transmitted, the transaction can be committed using the
stream_commit_cb callback (or possibly aborted using the
stream_abort_cb callback). If two-phase commits are supported, the transaction can be prepared using the
COMMIT PREPARED using the
commit_prepared_cb callback or aborted using the
One example sequence of streaming callback calls for one transaction may look like this:
stream_start_cb(...); <-- start of first block of changes stream_change_cb(...); stream_change_cb(...); stream_message_cb(...); stream_change_cb(...); ... stream_change_cb(...); stream_stop_cb(...); <-- end of first block of changes stream_start_cb(...); <-- start of second block of changes stream_change_cb(...); stream_change_cb(...); stream_change_cb(...); ... stream_message_cb(...); stream_change_cb(...); stream_stop_cb(...); <-- end of second block of changes [a. when using normal commit] stream_commit_cb(...); <-- commit of the streamed transaction [b. when using two-phase commit] stream_prepare_cb(...); <-- prepare the streamed transaction commit_prepared_cb(...); <-- commit of the prepared transaction
The actual sequence of callback calls may be more complicated, of course. There may be blocks for multiple streamed transactions, some of the transactions may get aborted, etc.
Similar to spill-to-disk behavior, streaming is triggered when the total amount of changes decoded from the WAL (for all in-progress transactions) exceeds the limit defined by
logical_decoding_work_mem setting. At that point, the largest top-level transaction (measured by the amount of memory currently used for decoded changes) is selected and streamed. However, in some cases we still have to spill to disk even if streaming is enabled because we exceed the memory threshold but still have not decoded the complete tuple e.g., only decoded toast table insert but not the main table insert.
Even when streaming large transactions, the changes are still applied in commit order, preserving the same guarantees as the non-streaming mode.
If you see anything in the documentation that is not correct, does not match your experience with the particular feature or requires further clarification, please use this form to report a documentation issue.