Re: When are index scans used over seq scans?

Tom Lane wrote:
> which is almost 80% of the entire runtime. Which is enormous.
> What are those column datatypes exactly?

Table "richard.sessions"
Column | Type | Modifiers
------------------------+-----------------------------+-----------
[unrelated columns removed]
starttimetrunc | timestamp without time zone |
finishtimetrunc | timestamp without time zone |
Indexes:
"rb_us_st_ft_idx" btree (starttimetrunc, finishtimetrunc)
"rb_us_st_ft_idx2" btree (finishtimetrunc, starttimetrunc)
Check constraints:
"date_check" CHECK (finishtimetrunc >= starttimetrunc)

Table "richard.duration"
Column | Type | Modifiers
--------+-----------------------------+-----------
ts | timestamp without time zone |

> Perhaps you are incurring a datatype conversion cost?

Not that I can tell.

> It seems more likely that the cpu_operator_cost is underestimated,

As you perdicted, increasing cpu_operator_cost from 0.0025 to 0.025 also
causes the planner to use the index on duration.

> which leads me to question what exactly is happening in those
> comparisons.

Your guess is as good as mine (actually, yours is much better). I can
put together a reproducable test case if you like..

--
Richard van den Berg, CISSP
-------------------------------------------
Trust Factory B.V. | www.dna-portal.net
Bazarstraat 44a | www.trust-factory.com
2518AK The Hague | Phone: +31 70 3620684
The Netherlands | Fax : +31 70 3603009
-------------------------------------------
Have you visited our new DNA Portal?
-------------------------------------------