On Sun, Jul 17, 2011 at 3:04 AM, Cédric Villemain <
> 2011/7/17 Ken Caruso <ken(at)ipl31(dot)net>:
> > On Sat, Jul 16, 2011 at 2:30 PM, Tom Lane <tgl(at)sss(dot)pgh(dot)pa(dot)us> wrote:
> >> Ken Caruso <ken(at)ipl31(dot)net> writes:
> >> > Sorry, the actual error reported by CLUSTER is:
> >> > gpup=> cluster verbose tablename;
> >> > INFO: clustering "dbname.tablename"
> >> > WARNING: could not write block 12125253 of base/2651908/652397108
> >> > DETAIL: Multiple failures --- write error might be permanent.
> >> > ERROR: could not open file "base/2651908/652397108.1" (target block
> >> > 12125253): No such file or directory
> >> > CONTEXT: writing block 12125253 of relation base/2651908/652397108
> >> Hmm ... it looks like you've got a dirty buffer in shared memory that
> >> corresponds to a block that no longer exists on disk; in fact, the whole
> >> table segment it belonged to is gone. Or maybe the block or file number
> >> in the shared buffer header is corrupted somehow.
> >> I imagine you're seeing errors like this during each checkpoint attempt?
> > Hi Tom,
> > Thanks for the reply.
> > Yes, I tried a pg_start_backup() to force a checkpoint and it failed due
> > similar error.
> >> I can't think of any very good way to clean that up. What I'd try here
> >> is a forced database shutdown (immediate-mode stop) and see if it starts
> >> up cleanly. It might be that whatever caused this has also corrupted
> >> the back WAL and so WAL replay will result in the same or similar error.
> >> In that case you'll be forced to do a pg_resetxlog to get the DB to come
> >> up again. If so, a dump and reload and some manual consistency checking
> >> would be indicated :-(
> > Before seeing this message, I restarted Postgres and it was able to get
> to a
> > consistent state at which point I reclustered the db without error and
> > everything appears to be fine. Any idea what caused this? Was it
> > to do with the Vacuum Full?
> Block number 12125253 is bigger that any block we can find in
> Should the table size be in the 100GB range or 2-3 GB range ?
> This should help decide: if in the former case, then probably at least
> a segment disappear or, in the later, the shared_buffer turn
> Ken, you didn't change RELSEG_SIZE, right ? (it needs to be change in
> source code before compile it yourself)
> In both case a hardware check is welcome I believe.
No I am using Pre-built Ubuntu binaries so no source changes. Hardware
appears to be fine, the controller is a P800 on a HP DL380 and all the
diagnostics indicate the disks, controller, and battery are doing well.
> Cédric Villemain 2ndQuadrant
> http://2ndQuadrant.fr/ PostgreSQL : Expertise, Formation et Support
In response to
pgsql-admin by date
|Next:||From: Alanoly Andrews||Date: 2011-07-18 13:16:07|
|Subject: WAL archiving to two locations in warm standby|
|Previous:||From: lst_hoe02||Date: 2011-07-17 10:40:28|
|Subject: Re: Maximum insert per second|