Unsupported versions: 6.3
This documentation is for an unsupported version of PostgreSQL.
You may want to view the same page for the current version, or one of the other supported versions listed above instead.
PostgreSQL
Prev Next

Chapter 20. Starting postmaster

Nothing can happen to a database unless the postmaster process is running. As the site administrator, there are a number of things you should remember before starting the postmaster. These are discussed in the section of this manual titled, "Administering Postgres." However, if Postgres has been installed by following the installation instructions exactly as written, the following simple command is all you should need to start the postmaster:

% postmaster
The postmaster occasionally prints out messages which are often helpful during troubleshooting. If you wish to view debugging messages from the postmaster, you can start it with the -d option and redirect the output to the log file:
% postmaster -d >& pm.log &
If you do not wish to see these messages, you can type
% postmaster -S
and the postmaster will be "S"ilent. Notice that there is no ampersand ("&") at the end of the last example.
Prev Home Next
Locale Support Up Adding and Deleting Users